Good day all,
I have an older camcorder I am looking to build a circut to patch the camcorder to my PC.
The problem is the camcorder only has the old RCA jacks as outputs.
I'm looking for a schematic & software to interface the 2 together.
My fabrication skills are average can can read schematics & solder reasonably well.
However am realy week in the programing department.
Can anyone point me in the right direction so that I can get this project underway?
Any assistance would be greatly appreciated.
OH Yes i know i can buy what i need........But where is the fun in that.
Thanx in advance