I want to confiure embedded device2(see below figure) from pc through embedded device1.
setup is
pc---(ethernet cable)---embedded device1====(console cable)===embedded device2
From the PC, using telnet I am login to embedded device1. Then from the telnet, I am executing picocom(same
as minicom or hyperterminal) on the device /dev/tts/0 of embedded device1. Then on the picocom terminal i
can only view the console bootup messages of the embedded device2 but i cannot write or configure the
embedded device2 through picocom.
Can any one help to solve this issue.