: I've just started learning about programming and need help creating a solution algorithm in psuedocode to the following problem.
: "You are required to develop a solution to a timekeeping problem. Two race times are to be entered in the form of hours, minutes, seconds, and hundredths of a second, and if the times entered are valid (valid times are between 8am and 11pm, minutes and seconds are between 0 and 59, hundredths are between 0 and 99, and finally the first time must be before the second time) the elapse time between the two is to be calculated and reported. It must be possible to calculate many elapse times and when there are no more, the total of valid elapse times and the number of errors are to be reported."
: I have to use modules, but haven't yet, so far all i've got is this -
: Prompt for race_time1, race_time2
: Get race_time1, race_time2
: IF race_time1 < race_time2 THEN
: elapse_time = race_time2 - race_time1
: Display elapse_time
: Increment total_elapse_times
: Increment error_elapse_times
: Display total_elapse_times, error_elapse_times
: UNTIL race_time = 0
: Its not the final thing yet obviously, but it was a quick run through, could someone help me flesh it out more, give me pointers and stuff on how to go about psudocoding this problem.
Try this, you do not say if lapsed times are consective or not like 08:23:40 then 08:35:34 then 09:49:54 and so on or not? :->
Do you want to enter more times Y/N?
If "NO" END the program
"check time routines"
IF TIME1>TIME2 DO "enter times"
If Time 1 Hour <8 or >23 then "enter times"
If Time 2 Hour <8 or >23 then "enter times"
If Time 1 Mins <0 or >59 then "enter times"
If Time 2 Mins <0 or >59 then "enter times"
If Time 1 Secs <0 or >59 then "enter times"
If Time 2 Secs <0 or >59 then "enter times"
If Time 1 Hundreths <0 or >99 then "enter times"
If Time 2 Hundreths <0 or >99 then "enter times"
You would need to calculate totals of hundreths of a second to subtract the results and convert this back into Hrs:Mins:Secs:Hundreths which you could do in another routine.
You could add up the "errors" in the above "check time routines" mentioned above.
As you are doing many elapsed times you can do all of the above in a loop putting the 1st time and 2nd time in a 2 dimensional array.
If the elapse times are consective then on putting in further values only one time would need to be entered.
TimeA(2)=TimeB(1),TimeB(2)=the next inputted time and so on like:->
A to B , B to C , C to D , D to E and so on so
you might need to keep swapping variable values?
Use two more variables throughout if you need to to calculate the total elapsed time(s).
Hope this helps.